1306 Appleby Ave, Baltimore, MD 21209
Date: Dec 17, 2013
Permit type: Plumbing
Description: Repl exist gas boiler (75,000 btu), 1/2" backflow preventer as per code.
Permit #: COM2013-27215
3737 Saint Victor St, Baltimore, MD 21225
Date: Dec 17, 2013
Permit type: Plumbing
Description: Replace 100 amp line / load side srv cable as per code.
Permit #: COM2013-27229
941 Brooks Lane, Baltimore, MD 21217
Date: Dec 17, 2013
Permit type: Plumbing
Description: Amend permit #com2013-20548, issued on 09/26/2013 without plans to add the following additional work: 8 plumbing fixtures. remove and replace plumbing fixtures - 3 unit as per code. original permit description:(com2013-20548) install new toilet in bath 1st floor. work done to code.
Permit #: COM2013-27238
750 S Macon St, Baltimore, MD 21224
Date: Dec 17, 2013
Permit type: Plumbing
Description: Install nfpa 13d sprinkler system, installing 14 heads (to new single family attached dwelling) as per plans and as per code.
Permit #: COM2013-24080
3209 Glendale Ave, Baltimore, MD 21234
Date: Dec 17, 2013
Permit type: Plumbing
Description: Install 100,000 btu oil fired boiler and provide non testable backflow preventer. work done to code.
Permit #: COM2013-27265
2424 N Ellamont St, Baltimore, MD 21216
Date: Dec 18, 2013
Permit type: Plumbing
Description: Bioler replacement btu and backflow prevention device
Permit #: MEC2013-01339
448 E Federal St, Baltimore, MD 21202
Date: Dec 18, 2013
Permit type: Plumbing
Description: 200 amp heavy up. furnish and install 15 lts 20 outlets. new dryer circuit, central heating hot water heater 9 circuits as per code.
Permit #: COM2013-27358
21 Mardrew Road, Baltimore, MD 21229
Date: Dec 18, 2013
Permit type: Plumbing
Description: Run 1" natural gas line to generator 200,000 btus standard pressure generator located front right side of house about 20 ft from house 10 ft from shrubbery as per code.
Permit #: COM2013-27417
2802 Berwick Ave, Baltimore, MD 21234
Date: Dec 18, 2013
Permit type: Plumbing
Description: Main water service pipe
Permit #: PLM2013-02610
2000 Fountain St, Baltimore, MD 21231
Date: Dec 18, 2013
Permit type: Plumbing
Description: Rough in 2 full baths, one kitchen, one washer, one garbage disposal, one icemaker, two hose bibbs, one 50 gal electric water heater. gas to one 25,000 btu stove & one 72,000 btu furnace as per code. *hvac by others* *awc per planning - elevation certificate and variance application on file. first floor is at 6.2 navd88. water heater and furnace must be elevated two (2) feet or more, above the first floor. all plumbing must be fitted with backflow devices. materials (e.g. wall board, insulation, flooring...) must be impervious to water damage.
Permit #: COM2013-26950
446 E Federal St, Baltimore, MD 21202
Date: Dec 18, 2013
Permit type: Plumbing
Description: 200 amp heavy up. furnish and install 15 lts 20 outlets. new dryer circuit, central heating hot water heater 9 circuits as per code.
Permit #: COM2013-27350
2001 Homewood Ave, Baltimore, MD 21218
Date: Dec 18, 2013
Permit type: Plumbing
Description: Install gas pipe to tankless w.h. 217,000 btu ran 1 1/4 gas line approx. 30' and pressure test all gas piping in house. house was vacant no meter in house for couple of years run gas line to furnace 3/4'' and stove 3/4'' as per code
Permit #: COM2013-27363
201 North Bend Road, Baltimore, MD 21229
Date: Dec 18, 2013
Permit type: Plumbing
Description: Installation of new alarm system (scope of work includes the installation of a fire alarm system in accordance with the attached drawings and nfpa code) as per plans and as per code.
Permit #: COM2013-23310
631 Denison St, Baltimore, MD 21229
Date: Dec 18, 2013
Permit type: Plumbing
Description: Install 150amp service, add 20 ckt, 1 new meter. install 6 new plumbing fixtures and reconstruction waste and waste piping. install 100,000 btu furnace w/ 2.5 ton a/c with ductwork, two bath fans. install gas pipe for 40,000 btu stove, furnace 100,000btu and 60,000 btu water heater. work done to code.
Permit #: COM2013-27377
202 N Culver St, Baltimore, MD 21229
Date: Dec 18, 2013
Permit type: Plumbing
Description: Install 1-200amp service, 20 ckts and 20 fixtures/devices. install 9 plumbing fixtures and reconstruction of waste and water, 3/4 back flow. install 1 elect. hot water heater. 50,000 btu stove, 80,000 btu furnace, repair 100 sq. ft. of drywall and patch wholes in kitchen and bedrooms. work done to code.
Permit #: COM2013-27426
3209 Milford Ave, Baltimore, MD 21207
Date: Dec 18, 2013
Permit type: Plumbing
Description: Bioler replacement btu and backflow prevention device
Permit #: MEC2013-01334
606 Cherry Hill Road, Baltimore, MD 21225
Date: Dec 18, 2013
Permit type: Plumbing
Description: (use)premises for food deli ,ans sell of snacks and coffee
Permit #: USE2013-04204
458 Elrino St, Baltimore, MD 21224
Date: Dec 18, 2013
Permit type: Plumbing
Description: Bioler replacement btu and backflow prevention device
Permit #: MEC2013-01336
208 Goodale Road, Baltimore, MD 21212
Date: Dec 19, 2013
Permit type: Plumbing
Description: Sewer pipe replacement
Permit #: PLM2013-02615
3604 Marmon Ave, Baltimore, MD 21207
Date: Dec 19, 2013
Permit type: Plumbing
Description: Main water service pipe
Permit #: PLM2013-02611